Skip to content
Waiter's ECC

Waiter's ECC

Complete Plug-and-Play solution. No wiring modifications required

Menu

Primary menu

  • HOME
  • POST
  • WAITER ECC
    • INSTALLATION
    • OPERATION
    • TECHNICAL
    • DOWNLOAD
    • FIRMWARE UPDATES
    • WALL PLATE
    • REMOTE DISPLAY
    • FAQs
  • WAITER LEGACY
    • OPERATION
    • TECHNICAL
    • DOWNLOAD
    • FAQs
  • BUY NOW
  • ABOUT
    • ABOUT US
    • CONTACT
    • WARRANTY / RETURN
    • SHIP OUTSIDE US

FAQ Category: WAITER ECC - OPERATION

question about the operation

What is full AUTO temperature control?

This feature was introduced as of version 4.3.0. When selected, it controls both the furnace and the A/C unit at the same time.  The HEAT and A/C set points are set individually by using the regular HEAT and A/C modes.  Continue reading What is full AUTO temperature control?→

Leave a reply

Whats that little gray square in the lower left corner of the temperature displays

This little box is a convenient reminder that you have a schedule running for either the FRONT or REAR system. When you have a schedule (click on the SCHED tab) activated and running, the little gray square will illuminate in Continue reading Whats that little gray square in the lower left corner of the temperature displays→

Leave a reply

Without an internet connection, how does it keep track of time?

The Waiter ECC utilizes its own Real Time Clock (RTC) module to keep track of time. Most installations are mobile, crossing time zones, passing in-to and out-of time zones, daylight savings times, etc. Since we can’t depend on an internet Continue reading Without an internet connection, how does it keep track of time?→

Leave a reply

Please explain SHEDDING

Most motorhomes that use these early model  Intellitec ECC system have a shore power capacity of 30 amps.  SHEDing is a way of preventing electrical loads inside the motorhome from exceeding 30 amps and tripping circuit breakers. SHED is when Continue reading Please explain SHEDDING→

Leave a reply

How does the A/C AUTO function work?

Waiters ECC method for A/C AUTO function behaves a little differently than the Intellitecs method. In A/C AUTO, the A/C blower speed is automatically changed as the temperature changes. The normal blower speed is LO. The blower will switch to Continue reading How does the A/C AUTO function work?→

Leave a reply

How does the screen know when to dim?

There are two “DIM” settings,  one for DAY and one for NIGHT. After about 30 seconds of no touch on the screen,  the screen will dim to either of these two settings.  Normally, when the screen is touched,  it goes Continue reading How does the screen know when to dim?→

Leave a reply

What is “Freeze Protection” ?

Most motor-homes that use the Intellitec control system have “basement heat”. These are storage compartments below the floor that water pipes run through and are heated by a duct from the furnace.  The compartments are poorly insulated and the only way Continue reading What is “Freeze Protection” ?→

Leave a reply

Primary Sidebar Widget Area

COMPARE FEATURES

Waiter ECC Comparison Chart
(Click image to enlarge)


BUY NOW

AVAILABLE OPTIONS

7" remote display touch screen

NEW PROJECTS

Heat pump support
Leveler control
Water heater control
Generator control
  • Facebook
Copyright © 2026 Waiter's ECC. All Rights Reserved.
Theme: Catch Box by Catch Themes
Scroll Up