Complete Plug-and-Play solution. No wiring modifications required
Installing the Waiter ECC
Almost every installation is unique, so its impossible to give a definitive answer. There are three factors that may help you in deciding. In almost every case, the existing hole in the wall needs to be made about 1/4 inch Continue reading Do I need the optional Wall Mount Plate
YES / NO – To gain the full functionality of the Waiter ECC, yes, you need to install it. Feedback from users tell us that its sometimes a pain to route the cable and install the sensor, but its Continue reading Do I really need the outside temperature sensor?
Two main reasons, If you need to re-boot the system, or you’re in storage with power, but don’t need to run the heat or A/C. 1) If the ON/OFF switch isn’t installed, the only way to reboot the system is Continue reading Why should I install the ON/OFF switch?
Yes, Use good quality cable, CAT 5 or CAT 6 would be OK. When you cut the cable and re-splice it, make sure to connect the wires to the correct color (Red, Yellow, and Black). In the vast majority of Continue reading The cable for my external temperature sensor is to short, Can I make it longer?
Many USB power supplies (powering the touch screen through its USB connector) can not produce reliable current flow to the touch screens computer. When this happens, its operation can become unreliable, rebooting, crashing, etc. We strongly suggest powering the touchscreen Continue reading Can I power my touch screen with a USB power supply
The Waiter ECC re-uses the enclosure from your existing control module. You remove the control module cover, pop out the old circuit board and install the new circuit board. All the plugs that plugged into the old circuit board will Continue reading Where does the new control module get install at?
In most installations, the new touch screen will be mounted at the same location as the original Intellitec operator panel. The mounting hole that the touchscreen fits into usually needs to be made slightly taller, about 1/8 to 1/4 inches. Continue reading What wood working modifications need to be done?
The Waiter ECC is plug and play, no electrical modifications are needed. Unplug the old system, plug in the new system, and you’re ready to go. However, we recommend installing an ON / OFF switch in the 12 volt power Continue reading Will electrical modifications need to be done?
In the vast majority of installations we’ve seen, the answer is YES, your original 10k temperature sensors will work just fine.. However, on older motorhomes that used a very early version of the Intellitec controller, you’ll need to upgrade your Continue reading Can I use the original temperature sensors?
In the vast majority of installations, the installer mounts the touchscreen the same location as the original operator panel. This allows the two temperature sensor plugs and the yellow (+) and brown (-) wires to be plugged into the touchscreen. Continue reading Where can I mount the operator touch screen?